Dumbbell Row
-
10-12 reps per side
-
Beginner
-
Lats + upper back
The single-arm dumbbell row trains one side of your back at a time, using a bench for support so you can focus on pulling without needing to stabilise your whole body against the load. It’s a good introduction to back training precisely because the setup removes a lot of the balance demand a barbell row has.
Meet Muscle Booster
- 3000+exercise library
- 70M+downloads
- 4.6rating**based on 128,000 AppStore ratings
Featured in
Muscles worked by Dumbbell Row
- Primary
Lats (latissimus dorsi)
Broad muscles running down the sides of your back, under your arms. They do most of the work, pulling your elbow back toward your hip.
- Primary
Upper back
A diamond-shaped sheet of muscle across your upper back. It is a main muscle here, drawing your shoulder blade toward your spine as you pull.
- Assisting
Biceps
The muscles you’d show off when flexing, on the front of your upper arm. They help bend your elbow to finish the pull.
- Assisting
Shoulders
The back part of the rounded cap over your shoulder joint. It helps pull your upper arm back at the top of each row.
How to do Dumbbell Row
-
Place one knee and hand on a bench, other foot on the floor, back flat.
-
Take the dumbbell in your free hand, with your arm hanging straight beneath your shoulder.
-
Press your support hand and knee firmly into the bench so your torso stays square.
-
Drive your elbow back and up toward your hip.
-
Lower slowly to a full stretch, finish your reps, then switch sides.
Why add Dumbbell Row to your plan
-
Trains each side independently
Helping correct imbalances.
-
Bench support
Makes it a beginner-friendly entry into back training.
-
A longer range of motion
Than many machine rows.
-
Complements pulldown/pulling exercises
For a fuller back routine.
Form mistakes to avoid
-
Rounding the back to add extra range
Straining the spine instead of the back muscles.
-
Rotating the torso to help lift the weight
Instead of keeping it square.
-
Pulling with a straight-arm motion
Instead of driving the elbow back.
-
Rushing the lowering phase
Instead of controlling the stretch.
Muscle Booster insight
Keep pressing your supporting hand and knee into the bench
Because one hand and knee rest on the bench, it’s tempting to treat that side as passive. But a stable base is what lets your working arm pull without your torso twisting. If your hips or shoulders rotate as you pull, your supporting side has probably relaxed. Press your hand and knee firmly into the bench for the whole set, so the full effort goes into your back instead of into rotation.
People also ask
FAQ
Find answers to common questions about this exercise.
Dumbbell row vs. barbell row — which is better for beginners?
Dumbbell row is generally more beginner-friendly, since the bench support reduces the balance and lower-back demand of a bent-over barbell row.
What muscles does a single-arm dumbbell row work?
The lats and mid-back are the main movers, with the biceps and rear shoulders helping finish the pull.
Should I rotate my torso during a dumbbell row?
No. Keep it square so the pulling effort goes into the back muscles. Pressing the support hand and knee into the bench helps.
How heavy should the dumbbell be for rows?
Heavy enough that the last couple of reps are hard, but light enough to keep your back flat and torso square.