Seated Cable Row
-
10-12 reps
-
Beginner
-
Lats
The seated row — done on a cable machine or a plate-loaded row machine — pulls a handle toward your torso while seated with your legs extended, building back thickness with a fixed, supported posture. Keeping your chest tall throughout the pull is what keeps the work on your back instead of your lower spine.
Meet Muscle Booster
- 3000+exercise library
- 70M+downloads
- 4.6rating**based on 128,000 AppStore ratings
Featured in
Muscles worked by Seated Cable Row
- Primary
Between the shoulder blades (rhomboids)
Small muscles linking your spine to your shoulder blades. A main muscle here, they squeeze your shoulder blades together as the handle reaches your belly.
- Primary
Lats (latissimus dorsi)
Broad muscles fanning out along the sides of your back, toward your armpits. They take much of the load, drawing your elbows back past your ribs.
- Assisting
Biceps
At the front of each upper arm, they help bend your elbows to bring the handle in.
- Assisting
Shoulders
The back part of your shoulder caps. They assist by drawing your upper arms behind your body as you finish the pull.
How to do Seated Cable Row
-
Sit with feet on the footplate, knees slightly bent, holding the handle with arms extended.
-
Sit tall with your chest up and your shoulders down.
-
Pull the handle toward your lower ribs, driving your elbows back.
-
Squeeze your shoulder blades together, using only a slight lean.
-
Extend your arms with control, keeping your torso upright, then repeat.
Why add Seated Cable Row to your plan
-
Builds back thickness
With a supported, beginner-friendly setup.
-
Constant resistance throughout the range
On cable versions, unlike some free-weight rows.
-
Easy to isolate the back
From leg or hip involvement.
-
Complements vertical pulls
Like lat pulldown, for a fuller back routine.
Form mistakes to avoid
-
Leaning too far back
Uses body momentum instead of the back muscles to pull.
-
Rounding the upper back forward
At the start of each rep instead of sitting tall.
-
Shrugging the shoulders up toward the ears
During the pull.
-
Using too wide or narrow a grip
Makes the elbow path feel awkward, rather than one that lets the elbows travel naturally back.
Muscle Booster insight
Sit tall at the start of every rep to keep the work on your back
Sitting tall does two jobs. It keeps your lower back in a safer position, and it stops body momentum from helping the pull, which is what makes a set feel harder in the right way. Rounding forward at the start of a rep, even slightly, lets you rock into the pull and take work off your back. Check your posture at the start of each rep, not only at the end of the pull.
People also ask
FAQ
Find answers to common questions about this exercise.
Seated row machine vs. cable row — is there a difference?
Yes — see the Seated Row page for the plate-loaded/lever-machine version specifically. In short: a cable keeps resistance relatively constant through the range and requires you to control the handle’s path yourself, while a plate-loaded machine follows a fixed mechanical path with a resistance curve set by its lever arm.
What muscles does a seated row work?
The mid-back and lats are the primary movers, with the biceps and rear shoulders helping to finish the pull.
How far back should I lean during a seated row?
Keep your torso tall and use only a slight lean. Leaning far back uses body momentum instead of the back muscles.
Seated row vs. bent-over row — which is easier to learn?
The seated row, since the supported seat and fixed posture remove much of the balance and lower-back demand of a bent-over row.