Barbell Bent Over Row
-
8-10 reps
-
Intermediate
-
Lats + upper back
The barbell bent-over row is a compound back exercise done from a hip-hinge position, pulling the bar to your lower ribs or upper stomach. Unlike a supported dumbbell row, your back has to hold the hinge position under load throughout the set — which is exactly where the exercise’s main risk and its main back-building benefit both come from.
Meet Muscle Booster
- 3000+exercise library
- 70M+downloads
- 4.6rating**based on 128,000 AppStore ratings
Featured in
Muscles worked by Barbell Bent Over Row
- Primary
Lats (latissimus dorsi)
Spread across the sides of your back, from under your arms down toward your waist. They drive the movement, pulling your elbows back as the bar rises.
- Primary
Upper back
Across your upper back, between your shoulder blades. It is a main muscle here, squeezing your shoulder blades together at the top of each pull.
- Assisting
Lower back (erector spinae)
Along both sides of your spine at the waist. They keep your back flat and steady for the whole set, and work hard doing it.
- Assisting
Glutes and hamstrings
Your buttock muscles and the muscles down the back of your thighs. They assist by holding your hips back in the bent-over position.
How to do Barbell Bent Over Row
-
Stand holding a barbell, hinge at the hips to roughly a 45-degree torso angle.
-
Lock in a flat back and braced core, with your arms extended and the bar hanging below your shoulders.
-
Pull the bar toward your lower ribs or upper stomach, driving your elbows back.
-
Squeeze your shoulder blades together while your torso angle stays the same.
-
Lower the bar under control, keeping the hip hinge held, then repeat.
Why add Barbell Bent Over Row to your plan
-
Builds back thickness
Through a compound, loadable movement.
-
Reinforces the hip-hinge pattern
Shared with deadlifts and RDLs.
-
Trains the whole back as a unit
Rather than isolating one area.
-
A natural companion to vertical pulls
Like lat pulldown, for complete back development.
Form mistakes to avoid
-
Rounding the lower back under load
Instead of maintaining a hip hinge with a flat spine.
-
Standing too upright
Turns the exercise into more of a shrug-and-curl than a row.
-
Using body momentum
Standing up partway to help lift heavier weight.
-
Pulling to the chest instead of the lower ribs
Which can strain the shoulders.
Muscle Booster insight
Set your hip hinge before the first pull and hold it
Most cues focus on the pull, but the bent-over position you set before the first rep is what your back must hold, under load, for the whole set. If it isn’t stable at the start, no cue will fix it mid-set. Do a few lighter reps and check that your torso angle stays the same from first rep to last. If it creeps upward as you tire, that’s your signal to lower the weight.
People also ask
FAQ
Find answers to common questions about this exercise.
Barbell row vs. dumbbell row — which builds more back thickness?
The barbell version generally allows heavier total loading since both arms work together, which can support back thickness over time — but the dumbbell row’s unilateral nature and bench support make it a more beginner-friendly starting point.
Should a bent-over row be pulled to the chest or the stomach?
On this page, the bar is pulled to the lower ribs or upper stomach. Pulling to the chest can strain the shoulders.
Is barbell bent-over row bad for the lower back?
It places demand on the lower back because it holds the hinge under load. Keep a flat back, a stable torso angle, and a weight you can control. This is general information, not medical advice.
What muscles does a barbell row work?
The mid-back and lats, with the lower back, glutes and hamstrings holding the hinge position isometrically.