Rear Delt Fly
-
12-15 reps
-
Beginner
-
Shoulders
The rear delt fly isolates the back of the shoulder, a muscle group that often gets far less direct attention than the front and side delts in typical training. Bent forward at the hips, you raise the weights out to the sides — squeezing the shoulder blades together, not just lifting the arms, is what actually makes it work.
Meet Muscle Booster
- 3000+exercise library
- 70M+downloads
- 4.6rating**based on 128,000 AppStore ratings
Featured in
Muscles worked by Rear Delt Fly
- Primary
Shoulders
The rounded caps over your shoulder joints. The back part does most of the work, lifting your arms out to the sides as you bend forward.
- Assisting
Between the shoulder blades (rhomboids)
Small muscles linking your spine to your shoulder blades. They assist by pulling your shoulder blades together at the top of each raise.
How to do Rear Delt Fly
-
Hold a light dumbbell in each hand, hinge forward at the hips to roughly 45 degrees.
-
Keep a flat back and neutral neck, with your arms hanging below your chest and a slight bend in your elbows.
-
Raise your arms out to the sides, leading with your elbows and squeezing your shoulder blades together.
-
Stop around shoulder height without shrugging.
-
Lower slowly under control, then repeat.
Why add Rear Delt Fly to your plan
-
Targets a muscle group
Most pressing exercises don’t train directly.
-
Supports shoulder balance and posture
Alongside front-delt-heavy pressing work.
-
Low load requirement
Accessible even with light dumbbells.
-
Complements rows and pulling exercises
That also involve the upper back.
Form mistakes to avoid
-
Using momentum or swinging the torso
Instead of isolating the rear delts.
-
Standing too upright
Instead of hinging forward, which reduces the isolation.
-
Shrugging the shoulders up
Toward the ears during the raise.
-
Using too much weight
Forces the traps and lower back to take over the movement.
Muscle Booster insight
Squeeze your shoulder blades together instead of just lifting your arms
It’s easy to treat this as lifting the weights out to the sides, but the shoulder blade squeeze at the top is what works the back of your shoulders. Think of your arms as along for the ride while your shoulder blades do the pulling. Drop the weight and exaggerate the squeeze for a set or two. That often works better than adding load while the squeeze stays vague and the weight swings.
People also ask
FAQ
Find answers to common questions about this exercise.
Why train rear delts specifically?
Most pressing and daily movement patterns emphasise the front of the shoulder; direct rear delt work helps balance that out and can support better shoulder posture.
Rear delt fly vs. face pull — what’s the difference?
Both target the rear shoulder and upper back, but a face pull (pulling toward the face on a cable) also involves more external rotation, while a rear delt fly is a more isolated raise.
What muscles does a rear delt fly work?
Primarily the rear deltoids, with the upper back muscles assisting the shoulder blade squeeze.
How heavy should the dumbbells be for rear delt fly?
Lighter than most people expect — since the rear delts are a smaller muscle group, using a weight that allows strict form without momentum matters more than lifting heavy.